In this episode, which might just be our nerdiest one yet, we are joined by Sam Feller, aka The Awkward Engineer. First and foremost he would like everyone to know that he is the awkward one, the engineering is top notch.
We're back! In this episode we talk about what we were busy doing on our "break", the different types and formats that solder comes in, and some unfortunate consequences that sometimes occur while eating chips.
Last week Chris was a guest on the Coriolis Effect, a podcast hosted by Bil Herd and Ben Jordan. Since we are still on hiatus (and because the episode was so great) we decided to repost the conversation.
Sometimes things are difficult to build....enter the help of custom tooling!
Intrusive soldering, also known as pin-in-paste, is a method that uses solder paste to solder the thru-hole leads instead of hand soldering, wave soldering, or selective soldering.
In this episode, we go over flux's role in fighting the oxide layer that forms during PCB assembly, the basic chemistry of flux, what cold solder joints are, and more.
It's a fact of life that defects and failed boards will sometimes occur, which is why it's so important to have a debugging procedure prepared to help your CM know how to move forward. In this episode, we talk about best practices on how to work with your CM when these problems arise.
We've finally managed to convince CircuitHub CAM Engineer, Dave Wilcox, to come back on the show to continue our series about the intricacies of PCB fabrication.
IPC is a global trade organization whose goal is to help OEMs, EMS, PCB manufacturers, and suppliers build electronics better. They provide numerous standards covering the electronics manufacturing supply chain as well as engineering education and training.
In today's episode, we are joined by Darren Beckwith, CTO of Barnacle Systems. Barnacle Systems is a startup based in Victoria, Canada which provides security and monitoring products for boats and yachts. We chat with Darren about his many years working at Carmanah Technologies where he worked as a firmware engineer along with a larger engineering team and some of the struggles he encountered after transitioning to a much smaller startup.
ESD (Electro Static Discharge) is an invisible, silent killer for PCBs. Protecting your boards from ESD damage while they're in the factory and being shipped to you is something we take very seriously. In today's episode we talk about what ESD is,how it damages your boards, and measures that should be taken to prevent this damage from occurring including what you can do at home.
